1. Before installation, check whether the sewage pipeline is smooth and the installation ground is clean.
2. Install the matching sealing ring on the sewage outlet of the toilet.
3. Determine the installation position of the toilet. Align the toilet (sewage outlet) with the water outlet of the pipe and slowly lower it, adjust the correct position, then (with chalk or whiteboard pen) mark the surrounding of the toilet and determine the installation holes.
4. Drill the mounting holes. Align the marked hole of the anchor screw, drill the installation hole with an impact drill (diameter is 10mm, depth is 60mm), and install the expansion rubber nail. (Generally, it is not necessary to install the foot screw) 5. Put glass glue on the inside of the marking line.
6. Install the toilet by aligning the installation hole and the surrounding glass glue, and slowly press down until it is level.
7. Put glass glue on the connection between the toilet and the ground, and trim the surrounding area to ensure the appearance.
8. Install the foot screw.
9. Connect the water inlet pipe and check whether the filter is installed.
10. Clean the floor and tools, do not use it immediately (it usually takes 24 hours for the glass glue to cure), and keep the surrounding area of the toilet away from water for 24 hours.